An easy K-cup dispenser to hold K-cups or coffee pods.
Difficulty
easy
Tools
Kreg Tools
Other Tools
-
Jigsaw
-
Miter Saw
-
Table Saw
-
Tape Measure
-
Drill (cordless)
-
Nail Gun
-
Sander
Materials
Wood Products
- 1 Board , 1x8 , 36"
- 1 Board , 1x6 , 24"
- 1 Board , 3/8" , 48"
Hardware & Supplies
- 1 Top pull
- 10 1 1/4" Kreg pocket hole screws
Cut List & Parts
- 1 Base , 3/4" x 4" x 7 1/4"
- 2 Sides , 3/4" x 7 1/4" x 12"
- 1 Back , 3/4" x 4" x 11 1/4"
- 4 Front pieces , 3/16" x 5 1/2" x 2"
- 1 Top , 3/8" x 5 1/2" x 5 5/8
- 1 Sub-top , 3/8" x 4" x 4 1/2"
- 1 Bottom front piece , 3/8" x 5 1/2" x 2"
Directions
-
Cut the base
Cut the base per the dimensions indicated.
-
Cut the sides
Cut two side panels per the dimensions indicated
-
Cut the back
Cut the back panel per the dimensions indicated
-
Cut the front pieces
Cut 5 front pieces per dimensions indicated
-
Cut the top
Cut the top per dimensions indicated
-
Cut the sub-top
Cut the sub-top per dimensions indicated
-
Join the two top pieces
Join the two top pieces by gluing and clamping
-
Join the sides to the base
Join the sides to the base by drilling pocket holes as shown in the base and attaching with 1 1/4" pocket hole screws.
-
Join the back to the sides
Join the back to the sides by drilling pocket holes as shown and attaching with 1 1/4" pocket hole screws.
-
Install the front pieces
Install the front pieces as shown by gluing and clamping
-
Install the top
Verify that the top fits. Sand as required.
-
Add top pull
Add a pull of your choice to the top and finish the dispenser.
