This beginner-friendly DIY Nightstand can be built in just one day. Customize it to fit into any decor style!
Tools
Kreg Tools
Other Tools
-
Drill/Driver
-
Jig saw
-
Brad nailer
-
Tape measure
-
Pencil
-
Safety Glasses
-
Hearing Protection
Materials
Wood Products
- 1 Plywood Sheet , 3/4” x 4’ x 8’
- 1 Plywood Sheet , 1/4” x 2’ x 4’
- 1 Select Pine Board , 1 x 2 x 8’
- 1 Select Pine Board , 1 x 4 x 8’
- 1 Roll of Iron On Edge Banding , 3/4"
- 1 Roll of Iron On Edge Banding , 2"
Hardware & Supplies
- 1 Box of 1-1/4" Kreg Pocket Hole Screws (See tools list)
- 1 Box of 1-1/4" Brad nails
- 1 Box of 1-1/4" Wood Screws
- 1 Wood Glue
Directions
-
Step 1
Drill pocket holes and assemble base with 1-1/4" pocket hole screws.
-
Step 2
Attach 1x2s to top using wood glue and 1-1/4" brad nails.
-
Step 3
Attach base to top with 1-1/4" pocket hole screws.
-
Step 4
Attach slide out support using wood glue and 1-1/4" brad nails.
-
Step 5
Insert slide out and attach stop with 1-1/4" wood screws. If desired, cut hole in top and back for flush mount outlets.
-
Step 6
Drill pocket holes and assemble drawer box with wood glue, 1-1/4" pocket hole screws and 1-1/4" brad nails.
-
Step 7
Install drawer using 16" drawer slides and included hardware. The Kreg drawer slide jig will help with installation.
-
Step 8
Install drawer front and pulls as desired. Pull for slide out will require a 8-32 x1" hanger bolt. Finished!
Check out the video for these plans on Kreg’s YouTube Channel – https://youtu.be/C1J-4GDf_Ok