Side Table with Wireless Charger

By Built by Bec Designs
unnamed18
unnamed16
unnamed17
Kreg Academy Kreg Academy

This sturdy side table with a built in wireless charger is the perfect addition to your living area. The rounded edges give this table a modern look. The best part is: You can customize it to fit your needs!

Difficulty moderate

Tools

Kreg Tools

Other Tools

  • Router
    Router
  • Miter saw
    Miter saw
  • Sander
    Sander
  • Drill
    Drill
  • Clamps
    Clamps
  • Upcut spiral bit
    Upcut spiral bit
  • Jigsaw
    Jigsaw
  • 1/4" roundover bit
    1/4
  • Frostner bit/drill
    Frostner bit/drill

Materials

Wood Products

  • 4 Boards , 3/4” x 1' x 6'

Hardware & Supplies

  • 1 Box of 1 1/4" Kreg Pocket Hole Screws (see tools list)
  • 1 80, 120, 220 grit sandpaper
  • 1 Wood glue
  • 1 Stain
  • 1 Wireless charger
  • 1 Double sided tale
See All Tools & Materials

Cut List & Parts

  • 1 Top , 3/4” x 10” x 24”
  • 2 Legs , 3/4” x 7” x 21”
  • 1 Top Support , 3/4” x 1.5” x 15”
  • 1 Center Support , 3/4” x 3/4” x 15”
See Full Cut List & Parts

Directions

  • Step One

    Cut the top boards about 2” longer than you need. Set your Pocket hole jig to 3/4” and the stop collar on the drill bit to 3/4”. Drill pocket holes on the backside of the boards, then glue and join them together using 1 1/4” pocket hole screws.

    Step 1

  • Step Two

    Cut the top to size with the Kreg Jig Track saw.

    Step 2

  • Step Three

    Cut the legs about 2” longer than you need. Pocket hole and glue them together like you did the top.

    Step 3

  • Step Four

    Cut the legs to size with the Kreg Jig Track saw.

  • Step Five

    Using a template such as a bowl or a cup, trace it on both sides of the top. This will be the template for your oval shape. Cut out the shape with a jigsaw.

    Step 5

  • Step Six

    Repeat this same process on the legs.

  • Step Seven

    Optional step: Use 1/4” roundover bit to roundover all sides of the top and legs.

    Step 7

  • Step Eight

    Trace the shape of the wireless charger on the underside of the table top. Mark 1/2” depth on the forstner bit using tape. Drill in the center until you reach the tape.

    Step 8

  • Step Nine

    With your router and upcut spiral bit, make shallow passes until you reach the same depth as the bottom of the hole you made with the forstner bit.

    Step 9

  • step Ten

    Using double sided tape, push your wireless charger into the hole you made. Make sure to test to see if your phone charges.

  • Step Eleven

    Attach the top support between the two oval shapes you made for the legs using pocket holes and screws.

    Step 11

  • Step Twelve

    Attach the middle support about 10” up from the bottom of the legs using pocket holes and screws.

    Step 12

  • Step Thirteen

    Sand, stain and you have a brand new table!

    Step 13